Configuring ip profile discovery – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 148
Brocade Network Advisor SAN + IP User Manual
81
53-1002949-01
Configuring IP profile discovery
4
Configuring IP profile discovery
NOTE
You must have the All IP Products AOR (area of responsibility) in your user account to discover new
products. For more information about user accounts, refer to
To configure profile discovery, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
NOTE
The Discovered Products table lists all products discovered through individual product
discovery, profile-based discovery, as well as Fabric discovery (from the SAN tab).
NOTE
DCB devices discovered through Fabric discovery (from the SAN tab) are automatically added
to IP discovery during rediscovery.
FIGURE 16
Discover Setup - IP dialog box