Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 853)

Brocade Network Advisor SAN + IP User Manual 797
53-1002949-01
Layer 3 access control list policy
22
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Network group configuration
The Management application allows you to filter traffic from a specific network group. A network
group is made up of one or more devices, networks, or network groups. Use the following
procedures to configure a network:
• “Viewing existing network groups” on page 797
• “Creating a network group” on page 798
• “Editing a network group” on page 799
• “Copying a network group” on page 800
• “Deleting a network group” on page 801
Viewing existing network groups
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 773
• “Editing a standard L3 ACL configuration” on page 775
• “Copying a standard L3 ACL configuration” on page 776
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
To view all existing network groups, complete the following steps.
1. Click the Network Group tab.
FIGURE 283 Network dialog box, Network Group tab