Policy monitor, Policy monitor overview, Chapter 47 – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1706: Chapter 47, “policy monitor, Ed in

Brocade Network Advisor SAN + IP User Manual
1663
53-1002949-01
Chapter
47
Policy Monitor
In this chapter
•
•
Preconfigured policy monitors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1670
•
•
•
•
•
•
•
•
•
•
Viewing historical reports for all policy monitors. . . . . . . . . . . . . . . . . . . . 1705
•
Viewing historical reports for a policy monitor. . . . . . . . . . . . . . . . . . . . . . 1705
Policy monitor overview
Use the Policy Monitor feature to provide best practice guidelines for network setup at the fabric,
switch, port, and device level, as well as software configurations at the Fabric OS, Ironware,
Network OS, and the Management application level.
Configuring policy monitors enables you to perform the following:
•
Provide selectable and configurable built-in rules to check for best practices
•
Schedule policies to run periodically
•
Run a policy manually (on demand)
•
Generate a report that will detail any issues found by the policy