Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1572)

Brocade Network Advisor SAN + IP User Manual 1525
53-1002949-01
IP historical performance monitoring
43
FIGURE 661 Data Collector wizard Threshold & Rearm dialog box
This dialog box allows you to establish a a threshold value that triggers a trap message when
the threshold is met, and to establish conditions for repeating threshold check and trap
messages.
20. Select Enable threshold and rearm events to enable the Threshold and Rearm selectors.
21. Select the Fixed Threshold value and assign a Threshold Trap Severity level.
22. Select the Fixed Rearm value and assign a Rearm Trap Severity level. If the Fixed Rearm value
is the exact value used to trigger rearming (repeating the threshold check and trap message),
select Absolute. If the Fixed Rearm value is expressed as a percentage of the threshold value,
select Percent of threshold.
23. This is the last dialog box of the Data Collector wizard. Click Finish to accept your entries.
Adding third-party device MIB objects manually
To add a third-party device MIB object manually, complete the following steps.
1. Copy the third-party device MIB objects to the Install_Home\conf\mibs\ip directory.
2. Go to Install_Home\conf\mibs and open the mibs_to_compile.txt in a text editor.
3. Add the MIB file names to the mibs_to_compile.txt file.