Agilent Technologies Signal Analyzer N9030a - Manual (Page 892)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Mode Setup
Restore Mode Defaults
Resets the state for the currently active mode by resetting the mode persistent setting to their
default values and by performing a mode preset. This function never causes a mode switch. This
function performs a full preset on the active mode.
Remote Command :INSTrument:DEFault
Key Path Mode Setup
Preset Type (Remote Command Only)
For compatibility with ESA/PSA, the command PRESet:TYPE is implemented as a no-op.
Mode All
Remote Command :SYSTem:PRESet:TYPE FACTory|MODE|USER
:SYSTem:PRESet:TYPE?
Example :SYST:PRES:TYPE FACT
Notes This command is supported for backward compatibility only. It is a no-op and does not change
the behavior of any preset operation.
Preset This is unaffected by Preset, but is set to MODE by Restore System Defaults, All.
State Saved No
Initial S/W Revision Prior to A.02.00
Global Settings
Opens a menu that allows you to switch certain Meas Global parameters to a Mode Global state.
These switches apply to all Modes that support global settings. No matter what Mode you are in
when you set the “Global Center Frequency” switch to on, it applies to all Modes that support
Global Settings.
Key Path Mode Setup
Initial S/W Revision Prior to A.02.00
Global Center Freq
The software maintains a Mode Global value called “Global Center Freq”.
892 Remote Language Compatibility Measurement Application Reference