Agilent Technologies Signal Analyzer N9030a - Manual (Page 806)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
For log amplitude interpolation and log frequency interpolation, the interpolation is computed as:
Interpolation modes determine how limit values are computed between points in the limit table. The
appearance of a limit trace is also affected by the amplitude scale, which may be linear or logarithmic.
Key Path Meas Setup, Limits, Properties, Interpolation
Remote Command :CALCulate:LLINe[1]|2|...6:CONTrol:INTerpolate:TYPE LOGarithmic |
LINear
:CALCulate:LLINe[1]|2|...6:CONTrol:INTerpolate:TYPE?
Example :CALC:LLIN:CONT:INT:TYPE LIN sets limit line 1 frequency interpolation to linear.
Preset Linear, not affected by Mode Preset, preset by Restore Mode Defaults.
State Saved Saved in instrument state.
Initial S/W Revision A.02.00
Amplitude Interpolation
Sets the interpolation to linear or logarithmic for the specified limiting points set, allowing you to
determine how limit trace values are computed between points in a limit table. See Frequency
Interpolation for the equations used to calculate limit values between points.
Key Path Meas Setup, Limits, Properties, Interpolation
Remote Command :CALCulate:LLINe[1]|2|...6:AMPLitude:INTerpolate:TYPE LOGarithmic |
LINear
:CALCulate:LLINe[1]|2|...6:AMPLitude:INTerpolate:TYPE?
Example :CALC:LLIN:AMPL:INT:TYPE LIN sets limit line 1 amplitude interpolation to linear.
Preset Logarithmic, not affected by Mode Preset, preset by Restore Mode Defaults.
State Saved Saved in instrument state.
Initial S/W Revision A.02.00
806 Remote Language Compatibility Measurement Application Reference