Agilent Technologies Signal Analyzer N9030a - Manual (Page 109)

3 Programming the Analyzer
IEEE 488.2 Common Commands
Service Request Enable
This command enables the desired bits of the service request enable register.
The query returns the value of the register, indicating which bits are currently enabled.
Remote Command *SRE
*SRE?
Example *SRE 22 Enables bits 1, 2, and 4 in the service request enable register.
Notes For related commands, see the STATus subsystem and SYSTem:ERRor[:NEXT]? commands.
Preset 0
Min 0
Max 255
Status Bits/OPC
dependencies Service Request Enable Register (all bits, 0 – 7).
Initial S/W Revision Prior to A.02.00
Status Byte Query
Returns the value of the status byte register without erasing its contents.
Remote Command *STB?
Example *STB? Returns a decimal value for the bits in the status byte register.
For example, if a 16 is returned, it indicates that bit 5 is set and one of the conditions monitored
in the standard event status register is set.
Notes See related command *CLS.
Status Bits/OPC
dependencies Status Byte Register (all bits, 0 – 7).
Initial S/W Revision Prior to A.02.00
Trigger
This command triggers the instrument. Use the :TRIGger[:SEQuence]:SOURce command to select
the trigger source.
Key Path No equivalent key. See related keys Single and Restart.
Remote Language Compatibility Measurement Application Reference 109