Agilent Technologies Signal Analyzer N9030a - Manual (Page 152)

3 Programming the Analyzer
STATus Subsystem
"Questionable Calibration Extended Failure Positive Transition" on page 154
Questionable Calibration Extended Failure Condition
This query returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Failure Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:FAILure:CONDition?
Example STAT:QUES:CAL:EXT:FAIL:COND?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Failure Enable
This command determines which bits in the Questionable Calibration Extended Failure Condition
Register will set bits in the Questionable Calibration Extended Failure Event register, which also
sets bit 9 of the Questionable Calibration Register. The variable is the sum of the
decimal values of the bits you want to enable.
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle?
Example STAT:QUES:CAL:EXT:FAIL:ENAB 1
Can be used to query if an EMI conducted alignment is needed.
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
152 Remote Language Compatibility Measurement Application Reference