Agilent Technologies Signal Analyzer N9030a - Manual (Page 887)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Mode Setup
Selecting any legacy analyzer from this menu performs an instrument preset and sets Span, Trace
Points, couplings, VBW/RBW ratio, and Span/RBW ratio appropriately, as shown in the table
below.
Remote
Language Start
Freq. Stop
Freq. Number of Trace
Points RF
Coupling
VBW/RBW Ratio
Span/RBW
Ratio
8560E/EC 30 Hz 2.9 GHz 601 AC 1 91
8561E/EC 30 Hz 6.5 GHz 601 AC 1 91
8562E/EC 30 Hz 13.2
GHz 601 AC 1 91
8563E/EC 30 Hz 26.5
GHz 601 DC 1 91
8564E/EC 30 Hz 40 GHz 601 DC 1 91
8565E/EC 30 Hz 50 GHz 601 DC 1 91
HP8566A 2 GHz 22 GHz 1001 DC 3
(VBW one step wider
than RBW)
106
HP8566B 2 GHz 22 GHz 1001 DC 3
(VBW one step wider
than RBW)
106
HP8568A 0 Hz 1.5 GHz 1001 DC 3
(VBW one step wider
than RBW)
106
HP8568B 0 Hz 1.5 GHz 1001 DC 3
(VBW one step wider
than RBW)
106
Span, Trace Points, Couplings, VBW/RBW Ratio, and Span/RBW Ratio Settings
Key Path Mode Setup
Cmd Error
Turning Cmd Error On or Off enables or disables the display of the "CMD ERR" error messages. The
default setting is On. The error message appears in the Message bar and also can be queried using
ERR?
. The error message occurs if either the command syntax or any of its parameters are
incorrectly formed. The selected value is preserved after presetting or power cycling the
instrument. Disabling the display of command errors disables the display of all error types.
The format of the errors are as follows:
1. CMD ERR,
Remote Language Compatibility Measurement Application Reference 887