Agilent Technologies Signal Analyzer N9030a - Manual (Page 788)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
Meas Setup
The Meas Setup key opens a menu of softkeys that allow you to control the most important
parameters for the current measurement.
In the Meas Setup menu, you may configure Averaging, by setting the Average Number and the Average
Type.
Key Path Front-panel key
Initial S/W Revision Prior to A.02.00
Average/Hold Number
Sets the terminal count number N for Average, Max Hold and Min Hold trace types. This number is an
integral part of how the average trace is calculated. Basically, increasing N results in a smoother
average trace.
See "More Information" on page 789 .
See "AVER:CLE command" on page 789 .
Key Path Meas Setup
Remote Command [:SENSe]:AVERage:COUNt
[:SENSe]:AVERage:COUNt?
Couplings
Restarting any of these functions (Average, Max Hold or Min Hold) restarts all of them, as there
is only one count.
Preset 100
State Saved Saved in instrument state
Min 1
Max 10000
Status Bits/OPC
dependencies See "Sweep/Control" on page 1152 for a discussion of the Sweeping, Measuring, Settling and
OPC bits, and the Hi Sweep line. All are affected when a sequence is reset.
Backwards Compatibility
Notes In the past, when changing the Average Count (now Average/Hold Number), you had to re-
start the trace at the beginning of a sweep to ensure valid average data. Now, the system will
ensure valid results when changing the count limit.
Initial S/W Revision Prior to A.02.00
788 Remote Language Compatibility Measurement Application Reference