Agilent Technologies Signal Analyzer N9030a - Manual (Page 1201)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
[:SENSe]:SWEep:EGATe:TIME?
Example SWE:EGAT:TIME 500 ms
Dependencies Gate View Sweep Time is initialized:
•
On Preset (after initializing delay and length).
•
Every time the Gate Method is set/changed.
Additionally, in the Swept SA measurement, whenever you do a Preset, or leave Gate View, the
analyzer remembers the Gate Delay and Gate Length settings. Then, when returning to Gate
View, if the current Gate Delay and/or Gate Length do not match the remembered values Gate
View Sweep Time is re-initialized.
1. Compute the location of the "gate stop" line, which you know is at time t = tmin + GateDelay
+ GateLength.
Preset 519.3 µs
WiMAX OFDMA: 5 ms
GSM/EDGE: 1 ms
State Saved Saved in instrument state
Min 1 µs
Max 6000 s
Initial S/W Revision Prior to A.02.00
Gate View Start Time
Controls the time at the left edge of the Gate View.
Key Path Sweep/Control, Gate, Gate View Setup
Remote Command [:SENSe]:SWEep:EGATe:VIEW:STARt
[:SENSe]:SWEep:EGATe:VIEW:STARt?
Example SWE:EGAT:VIEW:STAR 10ms
Notes Units of time are required or no units; otherwise an invalid suffix error message will be
generated. See error –131.
Preset 0 ms
State Saved Saved in instrument state
Min 0
Max 500 ms
Initial S/W Revision A.10.00
Remote Language Compatibility Measurement Application Reference 1201