Agilent Technologies Signal Analyzer N9030a - Manual (Page 663)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Key Path Input/Output, Output Config, I/Q Cal Out
Readback Off
Initial S/W Revision Prior to A.02.00
Aux IF Out
This menu controls the signals that appear on the SMA output on the rear panel labeled “AUX IF
OUT
The Aux IF Out functionality is only valid for RF and External Mixer inputs. When using the
External Mixing path, the Aux IF Out levels (for all three Options CR3, CRP, and ALV) will be
uncalibrated because the factory default Aux IF level was set to accommodate the expected IF
levels for the RF path.
Key Path Input/Output, Output Config
Remote Command :OUTPut:AUX SIF|AIF|LOGVideo|OFF
:OUTPut:AUX?
Dependencies The softkey does not appear in models that do not support the Aux IF Out.
Preset This is unaffected by a Preset but is set to OFF on a "Restore Input/Output Defaults" or "Restore
System Defaults->All”
State Saved Saved in Input/Output state
Readback line 1-of-N selection [variable]
Backwards Compatibility
Notes In the PSA, the IF output has functionality equivalent to the "Second IF" function in the X-
Series’ Aux IF Out menu. In the X-Series, it is necessary to switch the Aux IF Out to “Second IF”
to get this functionality, whereas in PSA it is always on, since there are no other choices. Hence
a command to switch this function to “Second IF” will have to be added by customers migrating
from PSA who use the IF Output in PSA.
Initial S/W Revision A.04.00
Off
In this mode nothing comes out of the “AUX IF OUT” connector on the rear panel. The connector
appears as an open-circuit (that is, it is not terminated in any way).
Key Path Input/Output, Output Config, Aux IF Out
Example OUTP:AUX OFF
Remote Language Compatibility Measurement Application Reference 663