Agilent Technologies Signal Analyzer N9030a - Manual (Page 625)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Key Path Input/Output, Corrections
Mode SA, DVB-T/H, DTMB, SEQAN, TDSCDMA
Dependencies This key will only appear if you have the proper option installed in your instrument.
Amplitude correction may not be available in all modes; if a mode does not support amplitude
correction, the Corrections key should be blanked while in that mode. If an application supports
corrections but the current measurement does not, then the key should be grayed out in that
measurement
Preset Corrections arrays are reset (deleted) by Restore Input/Output Defaults. They survive shutdown
and restarting of the analyzer application, which means they will survive a power cycle.
Initial S/W Revision A.02.00
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document
to specify which correction will be affected by the functions.
Key Path Input/Output, Corrections
Mode SA
Notes The selected correction is remembered even when not in the correction menu.
Preset Set to Correction 1 by Restore Input/Output Defaults
Readback Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction 6
Initial S/W Revision A.02.00
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document
to specify which correction will be affected by the functions.
Key Path Input/Output, Corrections
Mode SA
Notes The selected correction is remembered even when not in the correction menu.
Preset Set to Correction 1 by Restore Input/Output Defaults
Readback Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction 6
Initial S/W Revision A.02.00
Remote Language Compatibility Measurement Application Reference 625