Agilent Technologies Signal Analyzer N9030a - Manual (Page 662)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Key Path Input/Output, Output Config
Remote Command :OUTPut:IQ:OUTPut IQ1|IQ250|OFF
:OUTPut:IQ:OUTPut?
Example OUTP:IQ:OUTP IQ1
Couplings An I/Q Cable Calibration or an I/Q Probe Calibration will change the state of the Cal Out port as
needed by the calibration routine. When the calibration is finished the I/Q Cal Out is restored to
the pre-calibration state.
Preset Off
State Saved Saved in instrument state.
Range 1 kHz Square Wave|250 kHz Square Wave|Off
Readback Text 1 kHz|250 kHz|Off
Initial S/W Revision Prior to A.02.00
Saved State Saved in instrument state
1 kHz Square Wave
Turns on the 1 kHz square wave signal at the Cal Out port. This choice is only available with
option BBA.
Key Path Input/Output, Output Config, I/Q Cal Out
Readback I/Q 1kHz
Initial S/W Revision Prior to A.02.00
250 kHz Square Wave
Turns on the 250 kHz square wave signal at the Cal Out port. This choice is only available with
option BBA.
Key Path Input/Output, Output Config, I/Q Cal Out
Readback I/Q 250kHz
Initial S/W Revision Prior to A.02.00
Off
Turns off the signal at the Cal Out port. This choice is only available with option BBA.
662 Remote Language Compatibility Measurement Application Reference