Agilent Technologies Signal Analyzer N9030a - Manual (Page 1228)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
SCPI command is sent while the key is blanked, an error is returned.
Readback This key displays the value read back from TV Line
Status Bits/OPC
dependencies
The Status Operation Register bit 5 "Waiting for Trigger" is set at the same time as the Sweeping
or Measuring bit is set. It is cleared when the trigger actually occurs (that is, after the trigger
event occurs and all the applicable trigger criteria have been met). A corresponding pop-up
message ("Waiting for trigger") is generated if no trigger signal appears after approximately 2
sec. This message goes away when a trigger signal appears.
Initial S/W Revision Prior to A.02.00
TV Line
Selects the TV line number to trigger on. Line number range is dependent on the settings of the
Standard and Field menus within the TV trigger setup functions. When the line number is
incremented beyond the upper limit, the value will change to the lower limit and continue
incrementing from there. When the line number is decremented below the lower limit, the value
will change to the upper limit and continue decrementing from there.
Key Path Trigger, TV
Remote Command :TRIGger[:SEQuence]:TV:LINE
:TRIGger[:SEQuence]:TV:LINE?
Example TRIG:TV:LINE 20
TRIG:TV:LINE?
Notes The range of the TV line number is dependent on the settings of the Standard and Field menus
within the TV trigger setup functions.
Preset 17
State Saved Saved in instrument state
Min The minimum value is the minimum line, and rolls over to the maximum value. The minimum
line number depends on which Field and standard are selected.
Max The maximum value is the maximum line, and rolls over to the minimum value. The maximum
line number depends on which Field and standard are selected.
Initial S/W Revision Prior to A.02.00
Field
Accesses the menu to select the field.
1228 Remote Language Compatibility Measurement Application Reference