Agilent Technologies Signal Analyzer N9030a - Manual (Page 1141)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Source
Source Setting Query (Remote Command Only)
This query can be used to get certain settings from the Source when the Source Mode is set to
Tracking. The returned values are all in ASCII.
Remote Command :SOURce:SETtings?
Example :SOUR:SET?
Notes Returns a set of comma separated values as follows (no spaces):
source max frequency,source min frequency,source frequency resolution,source max amplitude,
source min amplitude,source amplitude resolution,source sweep max point,source start
frequency,source stop frequency,source start amplitude,source stop amplitude
Initial SW Revision A.10.01
Remote Language Compatibility Measurement Application Reference 1141