Agilent Technologies Signal Analyzer N9030a User Manual
Page 150
3 Programming the Analyzer
STATus Subsystem
Mode
All
Remote Command
:STATus:QUEStionable:CALibration:SKIPped:ENABle
:STATus:QUEStionable:CALibration:SKIPped:ENABle?
Example
STAT:QUES:CAL:SKIP:ENAB 1
Can be used to query if an EMI alignment skipped condition is detected
Preset
32767
Min
0
Max
32767
Status Bits/OPC dependencies
Sequential command
Initial S/W Revision
Prior to A.02.00
Questionable Calibration Skipped Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration Event
register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode
All
Remote Command
:STATus:QUEStionable:CALibration:SKIPped[:EVENt]?
Example
STAT:QUES:CAL:SKIP?
Preset
0
Status Bits/OPC dependencies
Sequential command
Initial S/W Revision
Prior to A.02.00
Questionable Calibration Skipped Negative Transition
This command determines which bits in the Questionable Calibration Skipped Condition register
will set the corresponding bit in the Questionable Calibration Skipped Event register when the
condition register bit has a negative transition (1 to 0). The variable
decimal values of the bits that you want to enable.
Mode
All
Remote Command
:STATus:QUEStionable:CALibration:SKIPped:NTRansition
150
Remote Language Compatibility Measurement Application Reference