Agilent Technologies Signal Analyzer N9030a - Manual (Page 1040)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Save
Line
#
Type of field Example Notes
“Amplitude Correction”
2 File Description (in quotes) “Correction Factors for 11966E” 60 characters max; may be empty but
may not be omitted. If exceeds 60
characters, error –233 Too much data
reported
3 Comment (in quotes) “Class B Radiated” 60 characters max; may be empty but
may not be omitted. . If exceeds 60
characters, error –233 Too much data
reported
4 Instrument Version, Model
# A.02.06,N9020A May be empty but may not be omitted
5 Option List, File Format
Version K03 LFE EXM ,01 May be empty but may not be omitted
6 Freq Unit to be used for all
frequency values in the file Frequency Unit,MHz assumed to be Hz if omitted
7 Antenna Unit Antenna Unit,None If omitted leaves the Antenna unit
unchanged. The amplitude unit in the
Antenna Unit field is a conversion
factor that is used to adjust the Y Axis
Units of the current mode, if the mode
supports Antenna Units. For more
details on antenna correction data, refer
to the Input/Output,Corrections key
description. Allowable values:
dBuv/m, dBuA/m, dBG, dBpT, None
8 Freq Interpolation Frequency Interpolation,Linear if omitted leaves the Freq Interpolation
unchanged. Allowable values: Linear,
Logarithmic
9 Bias value in mA Bias,0.00 If omitted leaves the Bias value
unchanged (added as of A.08.50)
10 Bias State Bias State,On If omitted leaves the Bias State
unchanged. Allowable values: On, Off
(added as of A.08.50)
11 Overlap, two values, Freq1
and Freq2, separated by
commas. Overlap,33500,40000 Uses Freq Unit from line 6. Thus, in
this example Freq1=33.5 GHz, Freq2=
40.0 GHz (see note below). If omitted
leaves the overlap unchanged (added as
of A.08.50)
12 DATA marker DATA Corrections data begins in the next line
1040 Remote Language Compatibility Measurement Application Reference