Agilent Technologies Signal Analyzer N9030a - Manual (Page 1240)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
When Paused, the label on the key changes to Resume. Pressing Resume un-pauses the
measurement. When you are Paused, pressing Restart, Single or Cont does a Resume.
Key Path Sweep/Control
Remote Command :INITiate:PAUSe
Dependencies Grayed out in Measurements that do not support Pausing.
Blanked in Modes that do not support Pausing.
Initial S/W Revision Prior to A.02.00
Key Path Sweep/Control
Remote Command :INITiate:RESume
Dependencies Grayed out in Measurements that do not support Pausing.
Blanked in Modes that do not support Pausing.
Initial S/W Revision Prior to A.02.00
Abort (Remote Command Only)
This command is used to stop the current measurement. It aborts the current measurement as
quickly as possible, resets the sweep and trigger systems, and puts the measurement into an "idle"
state. If the instrument is in the process of aligning when ABORt is sent, the alignment finishes
before the abort function is performed. So ABORt does not abort an alignment.
If the instrument is set for Continuous measurement, this command sets up the measurement and
initiates a new data measurement sequence. A new data acquisition (sweep) is taken once the
trigger condition is met.
If the instrument is set for Single measurement, it remains in the "idle" state until an :INIT:IMM
command is received.
Remote Command :ABORt
Example :ABOR
Notes If :INITiate:CONTinuous is ON, then a new continuous measurement starts immediately, with
sweep (data acquisition) occurring once the trigger condition has been met.
If :INITiate:CONTinuous is OFF, then :INITiate:IMMediate is used to start a single measurement,
with sweep (data acquisition) occurring once the trigger condition has been met.
Dependencies For continuous measurement, ABORt is equivalent to the Restart key.
Not all measurements support the ABORt command.
1240 Remote Language Compatibility Measurement Application Reference