Agilent Technologies Signal Analyzer N9030a - Manual (Page 86)

3 Programming the Analyzer
List of Supported SCPI Commands
:MMEMory:STORe:TRACe "Trace (+State)" on page 1036
:MMEMory:STORe:TRACe:DATA "Trace" on page 1044
:MMEMory:STORe:TRACe:REGister "Trace (+State)" on page 1036
O
:OUTPut:ANALog "Analog Out" on page 655
:OUTPut:ANALog:AUTO "Analog Out" on page 655
:OUTPut:AUX "Aux IF Out" on page 663
:OUTPut:AUX:AIF "In this mode the 2nd IF output is mixed with a local oscillator and mixer
to produce an arbitrary IF output between 10 MHz and 75 MHz with 500
kHz resolution. The phase noise in this mode will not be as good as in
Second IF mode. " on page 664
:OUTPut:DBUS1|DBUS[:STATe] "Bus Out On/Off" on page 661
:OUTPut:DBUS2[:STATe] "Bus Out On/Off" on page 661
:OUTPut[:EXTernal][:STATe] "RF Output" on page 1124
:OUTPut:IQ:OUTPut "I/Q Cal Out" on page 661
R
:READ:SANalyzer{0:9}? "RLC Swept SA Measurement Front-Panel & SCPI Reference" on page 784
S
[:SENSe]:ADC:DITHer:AUTO[:STATe] "Auto " on page 839
[:SENSe]:ADC:DITHer[:STATe] "ADC Dither" on page 838
[:SENSe]:ADC:RANGe "Auto" on page 843
[:SENSe]:AVERage:CLEar "Average/Hold Number" on page 788
[:SENSe]:AVERage:COUNt "Average/Hold Number" on page 788
[:SENSe]:AVERage[:STATe] "Trace/Detector" on page 1321
[:SENSe]:AVERage:TYPE "Average Type" on page 789
[:SENSe]:AVERage:TYPE:AUTO "Average Type" on page 789
[:SENSe]:BWIDth|BANDwidth[:RESolution] "Res BW " on page 549
[:SENSe]:BWIDth|BANDwidth
[:RESolution]:AUTO "Res BW " on page 549
86 Remote Language Compatibility Measurement Application Reference