Agilent Technologies Signal Analyzer N9030a - Manual (Page 1257)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
System
Key Path System, Power On, Configure Applications
Initial S/W Revision A.02.00
Select/Deselect
Toggles the currently highlighted application in the list.
Key Path System, Power On, Configure Applications
Initial S/W Revision A.02.00
Save Changes and Exit
Applies the configuration of the applications list. The marked applications will be pre-loaded in
memory the next time the instrument application is started, and the order of the applications in
the list will be the order of the applications in the Mode Menu.
After saving your changes, the analyzer asks you if you would like it to restart so that your
changes can take effect (see dialog box, below). If you choose not to restart, the changes will not
take affect until the next time you shut down and restart the analyzer.
Key Path System, Power On, Configure Applications
Remote Command :SYSTem:PUP:PROCess
Example :SYST:PUP:PROC This is the SCPI command for restarting the analyzer. You must Wait after
this command for the instrument application to restart
Notes The softkey will be grayed-out when the virtual memory of the selected applications exceeds
100% of the limit.
Notes You cannot use *WAI or *OPC? to synchronize operation after a restart. This command stops and
restarts the instrument application, thus the SCPI operation is terminated and restarted. A
remote program must use fixed wait time to resume sending commands to the instrument. The
wait time will be dependent upon which applications are pre-loaded.
Remote Language Compatibility Measurement Application Reference 1257