Agilent Technologies Signal Analyzer N9030a - Manual (Page 187)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
KS) Unlocks the save registers Yes Yes N/A "KS) (Unlock Registers)" on page 319
KS> Specifies preamp gain for
signal input 2 N/A No N/A
KS< Specifies preamp gain for
signal input 1 N/A No N/A
KS| Display memory address
write No No N/A
KS# Turns off YTX self-heating
correction No N/A N/A
KS/ Allows preselector to be
peaked manually No N/A N/A
KS123 Returns up to 1001 words
display memory No No N/A
KS125 Writes up to 1001 display
memory words No No N/A
KS126 Returns every Nth value of
a trace No No N/A
KS127 Sets analyzer to accept
binary display write No No N/A
KS39 Writes display memory
address in fast binary No No N/A
KS43 Sets SRQ 102 when
frequency limit exceeded No No N/A
KS91 Returns the amplitude error No No N/A
KS92 Specifies value DL, TH,
active mkr in display units No No N/A
KS94 Returns code for harmonic
number in binary No No N/A
KSA Sets amplitude units to
dBm Yes Yes N/A "KSA (Amplitude in dBm)" on page 320
KSa Selects normal detection Yes Yes N/A "KSa (Normal Detection)" on page 321
KSB Sets amplitude units to
dBmV Yes Yes N/A "KSB (Amplitude in dBmV)" on page 322
KSb Selects positive peak
detection Yes Yes N/A "KSb (Positive Peak Detection)" on page 323
Remote Language Compatibility Measurement Application Reference 187