Agilent Technologies Signal Analyzer N9030a - Manual (Page 651)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Measuring
Selects the Measuring trigger signal to be output to the Trig 1 Out or Trig 2 Out connector. This
signal is true while the Measuring status bit is true.
Key Path Input/Output, Output Config, Trig 1/2 Output
Example TRIG1:OUTP MEAS
Readback Measuring
Initial S/W Revision Prior to A.02.00
Main Trigger
Selects the current instrument trigger signal to be output to the Trig 1 Out or Trig 2 Out connector.
Key Path Input/Output, Output Config, Trig 1/2 Output
Example TRIG1:OUTP MAIN
Readback Main Trigger
Initial S/W Revision Prior to A.02.00
Gate Trigger
Selects the gate trigger signal to be output to the Trig 1 Out or Trig 2 Out connector. This is the
source of the gate timing, not the actual gate signal.
Key Path Input/Output, Output Config, Trig 1/2 Output
Example TRIG1:OUTP GTR
Readback Gate Trigger
Initial S/W Revision Prior to A.02.00
Gate
Selects the gate signal to be output to the Trig 1 Out or Trig 2 Out connector. The gate signal has
been delayed and its length determined by delay and length settings. When the polarity is
positive, a high on the Trig 1 Out or Trig 2 Out represents the time the gate is configured to pass
the signal.
Key Path Input/Output, Output Config, Trig 1/2 Output
Remote Language Compatibility Measurement Application Reference 651