Agilent Technologies Signal Analyzer N9030a - Manual (Page 153)

3 Programming the Analyzer
STATus Subsystem
Questionable Calibration Extended Failure Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Failure Event register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:FAILure[:EVENt]?
Example STAT:QUES:CAL:EXT:FAIL?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Failure Negative Transition
This command determines which bits in the Questionable Calibration Extended Failure Condition
register will set the corresponding bit in the Questionable Calibration Extended Failure Event
register when the condition register bit has a negative transition (1 to 0). The variable
is the sum of the decimal values of the bits that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition?
Example STAT:QUES:CAL:EXT:FAIL:NTR 1
EMI conducted align failure is not required.
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Remote Language Compatibility Measurement Application Reference 153