Agilent Technologies Signal Analyzer N9030a User Manual
Page 1140
6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Source
l
Amplitude Step = Auto
l
Power Sweep = 0 dB
l
Amplitude Offset = 0 dB
l
Source Sweep Reverse = Off
l
Multiplier Numerator = 1
l
Multiplier Denominator = 1
l
Freq Offset = 0 Hz
l
Point trigger is set to "Ext1"
The Source State is saved along with the state of the current Mode when you save a State, and is
recalled when that Mode State is recalled.
When the analyzer first starts up, a Source Preset is performed. In the Input/Output menu,
Restore Input/Output Defaults will also perform a Source Preset.
A Mode Preset, from modes that support the External Source, turns off the RF but does not
perform a Source Preset. Similarly, Source Preset does not perform a Mode Preset.
Source Preset does not change the Source Mode nor the selection of which physical source is
being used, nor does it release the current source (the source remains under the control of the
analyzer) nor exit the Source menu.
Key Path
Source
Mode
SA
Remote Command
:SOURce:PRESet
Example
:SOUR:PRES
Preset
Initiates a Source Preset
State Saved
No
Initial S/W Revision
A.06.01
1140
Remote Language Compatibility Measurement Application Reference