Agilent Technologies Signal Analyzer N9030a - Manual (Page 76)

3 Programming the Analyzer
List of Supported SCPI Commands
List of Supported SCPI Commands
When the N9061A application has been selected, the X-Series instrument supports only a subset of
SCPI commands.
The SCPI commands available while using the N9061A application are listed below.
To find a command in the list, search according to its first alphanumeric character, ignoring any
leading ":" or "[" characters. The sole exception to this is the asterisk [*] prefix, identifying IEEE
488.2 Common commands and queries; all these appear at the start of the list.
*
*CAL? "All" on page 1269
*CLS "Clear Status " on page 103
*ESE
*ESE?
"Standard Event Status Enable " on page 104
*ESR? "Standard Event Status Register Query " on page 105
*IDN? "Identification Query " on page 105
*OPC
*OPC?
"Operation Complete " on page 106
*OPT? "Query Instrument Options " on page 107
*RCL "Recall Instrument State " on page 107
*RST "*RST (Remote Command Only)" on page 108
*SAV "Save Instrument State " on page 108
*SRE
*SRE?
"Service Request Enable " on page 109
*STB? "Status Byte Query " on page 109
*TRG "Trigger " on page 109
*TST? "Self Test Query " on page 110
*WAI "Wait-to-Continue " on page 110
A
:ABORt "Abort (Remote Command Only)" on page 1240
76 Remote Language Compatibility Measurement Application Reference