Agilent Technologies Signal Analyzer N9030a - Manual (Page 820)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
Example :CALC:LLIN:OFFS:Y –3 dB sets the Y axis offset to –3 dB.
:CALC:LLIN:OFFSet:UPD will apply the Y axis offset to all points in the limit line, then reset the Y
axis offset to zero.
Preset 0 dB
State Saved Saved in instrument state.
Min -Infinity
Max +Infinity
Default Unit dB
Initial S/W Revision A.02.00
Apply Offsets to Limit Table
Adds the X and Y offsets to each point in the limit table, then resets the X and Y offset values to
zero. This has no effect on the position of the limit trace.
For example, if the X offset is –10 MHz and the Y offset is 1 dB, the values in the limit table will
be updated as follows: 10 MHz will be subtracted from each X value, 1 dB will be added to each Y
value. The offset values will then be reset to zero. The limit trace will not be moved and the limit
table will be updated to accurately reflect the currently-displayed limit trace.
Key Path Meas Setup, Limits, Edit, Offset
Remote Command :CALCulate:LLINe[1]|2|...6:OFFSet:UPDate
Example :CALC:LLIN:OFFS:UPD sets updates the limit table to reflect the X and Y offsets, then resets the
offsets to zero.
State Saved No state
Initial S/W Revision A.02.00
Scale X Axis
Matches the X Axis to the selected Limit, as well as possible.
For frequency limits and a frequency-domain X-axis, sets the Start and Stop Frequency to contain
the minimum and maximum Frequency of the selected Limit. The range between Start Frequency
and Stop Frequency is 12.5% above the range between the minimum and maximum Frequency so
that span exceeds this range by one graticule division on either side.
For time limits and a time-domain X-axis, sets the sweep time to match the maximum Time of the
selected Limit.
820 Remote Language Compatibility Measurement Application Reference