Agilent Technologies Signal Analyzer N9030a - Manual (Page 162)

3 Programming the Analyzer
STATus Subsystem
Questionable register.
Preset 0
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Integrity Positive Transition
This command determines which bits in the Questionable Integrity Condition register will set the
corresponding bit in the Questionable Integrity Event register when the condition register bit has
a positive transition (0 to 1). The variable is the sum of the decimal values of the bits
that you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:INTegrity:PTRansition
:STATus:QUEStionable:INTegrity:PTRansition?
Example STAT:QUES:INT:PTR 8
Measurement ‘became uncalibrated’ Summary will be reported to the Integrity Summary of the Status
Questionable register.
Preset 32767
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Questionable Integrity Signal Register
The following commands and queries are available for this register:
"Questionable Integrity Signal Condition" on page 163
"Questionable Integrity Signal Enable" on page 163
162 Remote Language Compatibility Measurement Application Reference