Agilent Technologies Signal Analyzer N9030a - Manual (Page 148)

3 Programming the Analyzer
STATus Subsystem
Example STAT:QUES:CAL?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Negative Transition
This command determines which bits in the Questionable Calibration Condition register will set
the corresponding bit in the Questionable Calibration Event register when the condition register
bit has a negative transition (1 to 0). The variable is the sum of the decimal values of
the bits that you want to enable.
Mode All
Remote Command :STATus:QUEStionable:CALibration:NTRansition
:STATus:QUEStionable:CALibration:NTRansition?
Example STAT:QUES:CAL:NTR 16384
Alignment is not required.
Preset 0
Min 0
Max 32767
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Positive Transition
This command determines which bits in the Questionable Calibration Condition register will set
the corresponding bit in the Questionable Calibration Event register when the condition register
bit has a positive transition (0 to 1). The variable is the sum of the decimal values of
the bits that you want to enable.
Mode All
Remote Command :STATus:QUEStionable:CALibration:PTRansition
:STATus:QUEStionable:CALibration:PTRansition?
Example STAT:QUES:CAL:PTR 16384
Alignment is required.
148 Remote Language Compatibility Measurement Application Reference