Agilent Technologies Signal Analyzer N9030a - Manual (Page 1035)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Save
Although these 16 registers are the only registers available from the front panel, there are 128
state registers available in the instrument. Registers 17–128 are only available from the SCPI
interface, using the *SAV command.
There is one set of 128 state registers in the instrument, not one set for each Mode. When a state
is saved, the Mode it was saved from is saved with it; then when it is recalled, the instrument
switches to that Mode.
After the save completes, the corresponding register menu key annotation is updated with the
date and time and the message "Register saved" is displayed.
Key Path Save, State
Mode All
Example *SAV 1
Range 1–16 from front panel, 1–128 from SCPI
Readback Date and time with seconds resolution are displayed on the key
OR
A custom name of up to 30 characters entered using the Edit Register Names key
OR
“(empty)" if no prior save operation has been performed to this register.
Initial S/W Revision Prior to A.02.00
Modified at S/W
Revision A.11.00
Edit Register Names
You may enter a custom name on any of the Register keys, to help you remember what you are
using that state to save. To do this, press the Edit Register Names key, choose the register whose
name you wish to edit, and then enter the desired label using the Alpha Editor or an external PC
keyboard.
The maximum number of characters that can be added is 30. In most cases, 30 characters will fit
on two lines of the key.
See "More Information" on page 1036
Key Path Save, State
Mode All
Remote Command :MMEMory:REGister:STATe:LABel ,”label”
Remote Language Compatibility Measurement Application Reference 1035