Agilent Technologies Signal Analyzer N9030a - Manual (Page 1208)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:EXTernal:LEVel
For backward compatibility, the parameter EXTernal is mapped to EXTernal1
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:FRAMe:EXTernal1:LEVel
Initial S/W Revision Prior to A.02.00
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on
a falling edge.
Key Path Trigger, External 1
Remote Command :TRIGger[:SEQuence]:EXTernal1:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:EXTernal1:SLOPe?
Example TRIG:EXT1:SLOP NEG
Couplings This same slope is used in the Ext1 selection for the trigger source in the Trigger menu and for
the period timer sync source (in the Trigger menu and in the Gate Source menu).
Preset POSitive
State Saved Saved in instrument state
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:EXTernal:SLOPe
For backward compatibility, the parameter EXTernal is mapped to EXTernal1
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:FRAMe:EXTernal1:SLOPe
Backwards Compatibility
Notes The legacy :TRIGger[:SEQuence]:SLOPe command affects the slopes for the VID, LINE, EXT1,
EXT2, and RFB triggers.
Initial S/W Revision Prior to A.02.00
External 2
Pressing this key, when it is not selected, selects an external input signal as the trigger. A new
sweep/measurement will start when the external trigger condition is met using the external 2
input connector. The external trigger 2 input connector is on the rear panel.
Pressing this key, when it is already selected, accesses the external 2 trigger setup menu.
Key Path Trigger
Example TRIG:SOUR EXT2 Swept SA measurement
1208 Remote Language Compatibility Measurement Application Reference