Source, Rf output – Agilent Technologies Signal Analyzer N9030a User Manual
Page 1124
6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Source
Source
There is no Source control functionality for this measurement. When this key is pressed, the
screen either displays a blank menu, or the previously-selected menu remains unchanged.
Key Path
Front-panel key
RF Output
Allows you to turn the source RF Power on or off.
As stated below, when the RF Output is turned on, the Source Mode is set to Tracking. See the
key description for special considerations concerning how to configure your
N5172B or N5182B source for use with External Source Control.
Key Path
Source
Scope
Meas Global
Remote Command
:OUTPut[:EXTernal] [:STATe] ON|OFF|1|0
:OUTPut[:EXTernal] [:STATe]?
Example
:OUTP ON
:OUTP?
Dependencies
Grayed out in measurements that do not support a source. If you go to such a measurement the
output will be forced to Off.
Grayed out if there is no valid source selection, in this case go to the Select Source menu to
choose, configure and/or verify your source
When there is no available Source Mode (other than Off), due to other couplings, then the RF
Ouput key is grayed out.
Couplings
When RF Output is turned On, Source Mode is set to Tracking
When Source Mode is turned Off, RF Output is turned Off.
When Source Mode is turned Off (or forced to Off by another coupling), RF Output is turned Off.
Turning RF Output Off does not affect Source Mode or other settings.
Preset
OFF (on either a Mode Preset, a Source Preset, or Restore Input/Output Defaults)
State Saved
Part of the Input/Output system, which means it is Loaded and Saved with state.
Range
On | Off
Initial S/W Revision
A.06.01
Modified at S/W
Revision
A.10.01
1124
Remote Language Compatibility Measurement Application Reference