Agilent Technologies Signal Analyzer N9030a - Manual (Page 163)

3 Programming the Analyzer
STATus Subsystem
"Questionable Integrity Signal Event Query" on page 164
"Questionable Integrity Signal Negative Transition" on page 164
"Questionable Integrity Signal Positive Transition" on page 164
Questionable Integrity Signal Condition
This query returns the decimal value of the sum of the bits in the Questionable Integrity Signal
Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode All
Remote Command :STATus:QUEStionable:INTegrity:SIGNal:CONDition?
Example STAT:QUES:INT:SIGN:COND?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Integrity Signal Enable
This command determines which bits in the Questionable Integrity Signal Condition Register will
set bits in the Questionable Integrity Signal Event register, which also sets the Integrity Summary
bit (bit 9) in the Questionable Register. The variable is the sum of the decimal values of
the bits you want to enable.
Mode All
Remote
Command :STATus:QUEStionable:INTegrity:SIGNal:ENABle
:STATus:QUEStionable:INTegrity:SIGNal:ENABle?
Example STAT:QUES:INT:SIGN:ENAB 4
Burst Not Found will be reported to the Integrity Summary of the Status Questionable register.
Preset 32767
Min 0
Max 32767
Status
Bits/OPC
dependencies Sequential command
Initial S/W
Revision Prior to A.02.00
Remote Language Compatibility Measurement Application Reference 163