Agilent Technologies Signal Analyzer N9030a - Manual (Page 1222)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Sweep/Control
Initial S/W Revision Prior to A.02.00
Modified at S/W
Revision A.03.00
Trigger Level
Sets the value where the external 2 trigger input will trigger a new sweep/measurement.
Key Path Trigger, External 2
Remote Command :TRIGger[:SEQuence]:EXTernal2:LEVel
:TRIGger[:SEQuence]:EXTernal2:LEVel?
Example TRIG:EXT2:LEV 1.1 V
Couplings This same level is used for the Ext2 trigger source in the Trigger menu, for the Ext2 selection in
the Periodic Timer sync source (in the Trigger menu and in the Gate Source menu), and also for
the Ext2 selection in the Gate Source menu.
Preset 1.2 V
State Saved Saved in instrument state
Min –5 V
Max 5 V
Default Unit V
Backwards
Compatibility SCPI :TRIGger[:SEQuence]:FRAMe:EXTernal2:LEVel
Initial S/W Revision Prior to A.02.00
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on
a falling edge.
Key Path Trigger, External 2
Remote Command :TRIGger[:SEQuence]:EXTernal2:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:EXTernal2:SLOPe?
Example TRIG:EXT2:SLOP NEG
Couplings This same slope is used in the Ext2 selection for the trigger source in the Trigger menu and for
the period timer sync source (in the Trigger menu and in the Gate Source menu).
1222 Remote Language Compatibility Measurement Application Reference