Agilent Technologies Signal Analyzer N9030a - Manual (Page 650)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
Polarity
Sets the output to the Trig 1 Out or Trig 2 Out connector to trigger on either the positive or
negative polarity.
Key Path Input/Output, Output Config, Trig 1/2 Output
Remote Command :TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity POSitive |
NEGative
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity?
Example TRIG1:OUTP:POL POS
Preset This is unaffected by a Preset but is set to POSitive on a "Restore Input/Output Defaults" or
"Restore System Defaults->All"
State Saved Saved in instrument state
Initial S/W Revision Prior to A.02.00
Off
Selects no signal to be output to the Trig 1 Out or Trig 2 Out connector.
Key Path Input/Output, Output Config, Trig 1/2 Output
Example TRIG1:OUTP OFF
Readback Off
Initial S/W Revision Prior to A.02.00
Sweeping (HSWP)
Selects the Sweeping Trigger signal to be output to the Trig 1 Out or Trig 2 Out connector when a
measurement is made. This signal has historically been known as "HSWP" (High = Sweeping), and
is 5 V TTL level with 50 ohm output impedance.
Key Path Input/Output, Output Config, Trig 1/2 Output
Example TRIG1:OUTP HSWP
Readback Sweeping
Initial S/W Revision Prior to A.02.00
650 Remote Language Compatibility Measurement Application Reference