Agilent Technologies Signal Analyzer N9030a User Manual
Page 834
6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Meas Setup
•
"All other Models" on page 835
Key Path
Meas Setup, PhNoise Opt
Remote Command
[:SENSe]:FREQuency:SYNThesis:AUTO[:STATe] OFF|ON|0|1
[:SENSe]:FREQuency:SYNThesis:AUTO[:STATe]?
Example
FREQ:SYNT:AUTO ON
Preset
ON
State Saved
Saved in instrument state.
Initial S/W Revision
Prior to A.02.00
Modified at S/W
Revision
A.12.00
Models with Option EP1
Auto will choose:
Fast Tuning whenever:
Span > 44.44 MHz, or when
RBW > 1.9 MHz, or if
Source Mode is set to “Tracking”
otherwise Auto will choose Best Close in Phase Noise whenever:
Center frequency is < 195 kHz, or when
CF >= 1 MHz and Span <= 1.3 MHz and RBW <= 75 kHz
otherwise, Auto will choose Best Wide-offset Phase Noise
The RBW to be used in the calculations above is the equivalent –3 dB bandwidth of the current
RBW filter.
These rules apply whether in swept spans, zero span, or FFT spans.
Models with Option EP2
Auto will choose:
Best Close-in Φ Noise whenever:
CF < 130 kHz , or when
CF > 12 MHz and Span < 495 kHz and RBW < 40 kHz
Otherwise, Auto will choose Fast Tuning whenever:
834
Remote Language Compatibility Measurement Application Reference