Brocade Network OS Command Reference v4.1.0 - Manual (Page 98)

60 Network OS Command Reference
53-1003115-01
cbs
2
cbs
Mandatory command for configuring the controlled burst size for a class-map.
Synopsis cbs cbs-size
no cbs cbs-size
Operands cbs-size Controlled burst size. Valid values range from 1250 through 5000000000
bytes in increments of 1 byte. This is a mandatory parameter for
configuring a class-map.
Defaults None
Command Modes Policymap class police configuration mode
Description This command sets the controlled burst size for a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples This example configures a class-map called “default” within a policy-map.
switch# configure terminal
switch(config)# policy-map policymap1
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)# cbs 50000
See Also conform-set-dscp, conform-set-prec, conform-set-tc, ebs, eir, exceed-set-dscp, exceed-set-prec,
exceed-set-tc, police cir, police-priority-map, policy-map, qos cos, service-policy, set-priority