Brocade Network OS Command Reference v4.1.0 - Manual (Page 511)

Network OS Command Reference 473
53-1003115-01
maximum-paths (BGP)
2
maximum-paths (BGP)
Changes the maximum number of BGP4 shared paths.
Synopsis maximum-paths num | use-load-sharing
no maximum-paths
Operands num Maximum number of paths across which the device balances traffic to a
given BGP4 destination.
use-load-sharing Uses the maximum IP ECMP path value that is configured by means of the
ip load-sharing command.
Defaults This option is disabled.
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to change the maximum number of BGP4 shared paths, either by setting a
value or using the value configured by the ip load-sharing command.
Usage Guidelines Use the no form of this command to restore the default.
Examples The following example sets the maximum number of BGP4 shared paths to 8.
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# maximum-paths 8
See Also ip load-sharing, maximum-paths ebgp ibgp (BGP)