Brocade Network OS Command Reference v4.1.0 - Manual (Page 649)

Network OS Command Reference 611
53-1003115-01
redistribute (OSPF)
2
redistribute (OSPF)
Configures the device to redistribute OSPF routes.
Synopsis redistribute ospf {match [external1 | external2 | internal]} [metric num] | route-map string
no redistribute ospf {match [external1 | external2 | internal]} [metric num] | route-map string
Operands match Selects the type of route to be redistributed.
external1 Redistributes OSPF external type 1 routes.
external2 Redistributes OSPF external type 2 routes.
internal Redistributes OSPF internal routes.
num A value that assigns the metric.The range is from 0 through 4294967297.
string Specifies a route map to be consulted before an OSPF route is added to the
BGP4 routing table.
Defaults Internal OSPF routes are distributed. No value is assigned for num.
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to redistribute OSPF external type 1, external type 2, or internal routes.
Usage Guidelines Use the redistribute ospf command to redistribute all OSPF routes. Use the no form of the
command to restore the defaults.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# redistribute ospf match external1 metric 200
See Also default-metric (OSPF)