Brocade Network OS Command Reference v4.1.0 - Manual (Page 433)

Network OS Command Reference 395
53-1003115-01
ip route next-hop ospf
2
ip route next-hop ospf
Enables static-route next-hop-resolution with OSPF routes.
Synopsis ip route next-hop ospf
no ip route next-hop ospf
Operands There are no operands for this command.
Defaults Disabled
Command Modes RBridge ID configuration mode
Description Use this command to enable a Brocade device to use routes learned from a specified protocol to
resolve a configured static route.
Usage Guidelines Enter no ip route next-hop ospf to disable static-route next-hop-resolution with OSPF routes.
Examples To enable static-route next-hop-resolution with OSPF routes:
switch (config)# rbridge-id 30
switch (config-rbridge-id-30)# ip route next-hop ospf
See Also ip route next-hop-enable-default, ip route next-hop-recursion, ip route next-hop-vrf