Brocade Network OS Command Reference v4.1.0 - Manual (Page 351)

Network OS Command Reference 313
53-1003115-01
ha disable
2
ha disable
Disables the High Availability feature.
Synopsis ha disable
Operands None
Defaults HA is disabled.
Command Modes Privileged EXEC mode
Description Use this command to disable the High Availability (HA) feature on a switch. If the HA feature is
already disabled, this command has no effect.
Usage Guidelines This command is supported only on the active management module.
This command is not supported on the standby management module.
Do not use this command unless instructed by Brocade Technical Support.
NOTE
With the introduction of Network OS 4.0, failover is no longer disruptive for Layer 2.
Examples To display the syslog daemon IP addresses configured on a switch:
switch# ha disable
Service instances out of sync
1970/01/01-00:06:30, [HASM-1101], 111, MM1, WARNING, chassis, HA State out of
sync.
HA is disabled
See Also ha enable, reload, show ha