Brocade Network OS Command Reference v4.1.0 - Manual (Page 785)

Network OS Command Reference 747
53-1003115-01
show edge-loop-detection interface
2
show edge-loop-detection interface
Displays ELD interface configuration information and packet statistics.
Synopsis show edge-loop-detection interface interface-type interface-id
show edge-loop-detection interface {tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port | port-channel number}
Operands interface-type Specifies an interface type.
interface-id Specifies an interface ID.
tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This value is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This value is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number Specifies the interface is a port-channel. Valid values range from 1
through 6144.
Defaults None
Command Modes Privileged EXEC mode
ELD configuration mode
Description Use this command to view the ELD configuration settings and status for a specific interface and to
view the number of packets received and transmitted.
Usage Guidelines This functionality detects Layer 2 loops only.
Examples To view the ELD status for a specific interface:
switch(conf-if-te-7/0/5)# do show edge-loop-detection interface
tengigabitethernet 7/0/5
Number of eld instances: 1
Enabled on VLANs: 100
Priority: 128
Interface status: UP
Auto enable in: Never
Packet Statistics:
vlan sent rcvd
100 100 0
switch(conf-if-te-7/0/5)# do show edge-loop-detection rbridge-id 7