Brocade Network OS Command Reference v4.1.0 - Manual (Page 532)

494 Network OS Command Reference
53-1003115-01
neighbor capability as4 (BGP)
2
neighbor capability as4 (BGP)
Enables or disables support for 4-byte autonomous system numbers (ASNs) at the neighbor or
peer-group level.
Synopsis neighbor {ip-address | peer-group-name} capability as4 [enable | disable]
no neighbor capability as4
Operands ip-address IPv4 address of the neighbor
peer-group-name Peer group name configured by the neighbor peer-group-name command.
enable Enables 4-byte numbering.
disable Disables 4-byte numbering.
Defaults Four-byte ASNs are disabled by default.
Command Modes BGP configuration mode
Description Use this command to enable 4-byte ASNs at the neighbor or peer-group level.
Usage Guidelines 4-byte ASNs are first considered at the neighbor, then at the peer group, and finally at the global
level.
Use the disable keyword or the no form of this command to remove all neighbor capability for AS4.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# neighbor 10.11.12.13 capability as4 enable
See Also None