Brocade Network OS Command Reference v4.1.0 - Manual (Page 935)

Network OS Command Reference 897
53-1003115-01
show ip pim-sparse
2
show ip pim-sparse
Displays the Protocol Independent Multicast (PIM) router parameters.
Synopsis show ip pim-sparse [interface {tengigabitethernet rbridge-id /slot/port |
gigabitethernet rbridge-id/slot/port | fortygigabitethernet rbridge-id /slot/port | ve vlan_id}]
Operands tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
fortygigabitethernet rbridge-id/slot/port
Specifies a valid 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
ve vlan_id Specifies a virtual Ethernet (VE) interface. Refer to the Usage Guidelines.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display the internal parameters of the PIM router. It also displays the
parameters of the PIM enabled interface.
Usage Guidelines On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows:
• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
Examples A typical output for this command.
switch# show ip pim-sparse
Global PIM Sparse Mode settings
Maximum mcache: 2048 Current count: 0
Hello interval: 30 Neighbor timeout: 105