Brocade Network OS Command Reference v4.1.0 - Manual (Page 1396)

1358 Network OS Command Reference
53-1003115-01
vlag ignore-split
2
vlag ignore-split
Controls the ignore-split recovery functionality.
Synopsis vlag ignore-split
no vlag ignore-split
Operands None
Defaults vlag ignore-split is enabled.
Command Modes Port-channel configuration mode
Description Use this command to enable or disable the ignore-split recovery functionality.
When ignore-spilt-recovery is active, neither of the RBridges modify their actor SID when splitting
or rejoining the vLAG. They both advertise VSID and keep both sides of the vLAG alive.
Usage Guidelines This command is supported only when the switch is operating in Brocade VCS Fabric mode.
Enter no vlag ignore-split to disable this functionality.
NOTE
It is recommended that this command be enabled.
Examples
switch(config)# interface port-channel 27
switch(config-port-channel-27)# vlag ignore-split
See Also None