Brocade Network OS Command Reference v4.1.0 - Manual (Page 437)

Network OS Command Reference 399
53-1003115-01
ip router-id
2
ip router-id
Configures router ID.
Synopsis ip router-id A.B.C.D
no ip router-id A.B.C.D
Operands A.B.C.D Specifies the IPv4 address that you want as the router ID.
Defaults None
Command Modes RBridge ID configuration mode
Description Use this command to set a router ID (the 32-bit number that uniquely identifies the device).
By default, the router ID is the numerically lowest IP interface configured on the device, but you
can explicitly set the router ID to any valid IP address that is not in use on another device in the
network.
Usage Guidelines Enter no ip router-id A.B.C.D to remove the router ID and use the default router ID.
Examples To specify a router ID of 192.158.1.2:
switch (config)# rbridge-id 30
switch (config-rbridge-id-30)# ip router-id 192.158.1.2
See Also None