Brocade Network OS Command Reference v4.1.0 - Manual (Page 1087)

Network OS Command Reference 1049
53-1003115-01
show running-config interface gigabitethernet sflow
2
show running-config interface gigabitethernet sflow
Displays the sFlow configuration for a 1-gigabit Ethernet interface.
Synopsis show running-config interface gigabitethernet [rbridge-id/slot/port] sflow [enable |
polling-interval | sample-rate]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
enable Displays whether sFlow is enabled for the port.
polling-interval Displays the configured maximum number of seconds between successive
samples of counters to be sent to the collector.
sample-rate Displays the number of packets that are skipped before the next sample is
taken for the interface.
Defaults Displays all sFlow configuration information for the port.
Command Modes Privileged EXEC mode
Description Use this command to display the sFlow configuration for the specified interface.
Usage Guidelines This command can be used only on Brocade VDX 6710, Brocade VDX 8770-4, and
Brocade VDX 8770-8 switches.
Examples
switch# show running-config interface gigabitethernet 1/0/8 sflow
interface Gigabit Ethernet 1/0/8
sflow enable
sflow polling-interval 10
sflow sample-rate 100
!
See Also sflow enable (interface version), sflow polling-interval (interface version),
sflow sample-rate (interface version)