Brocade Network OS Command Reference v4.1.0 - Manual (Page 122)

84 Network OS Command Reference
53-1003115-01
class-map
2
class-map
Enters class-map configuration mode.
Synopsis class-map class-map-name
no class-map class-map-name
Operands class-map-name Name of classification map. The map name is restricted to 64 characters.
Defaults The class-name “class-default” is reserved and cannot be created by users.
Command Modes Global configuration mode
Description Use this command to enter class-map configuration mode.
Usage Guidelines Enter no map class-map name while in global configuration mode to remove the classification
map.
Only 128 class maps are allowed.
NOTE
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Examples To create a classification map and place system into config-classmap mode:
switch(config)# class-map default
switch(config-classmap)#
NOTE
The class map created using class map becomes the default class-map and cannot be removed
using the no class-map command. You can remove a class-map from a policy map however.
See Also show running-config class-map, match interface police-priority-map, policy-map, qos cos,
service-policy