Brocade Network OS Command Reference v4.1.0 - Manual (Page 652)

614 Network OS Command Reference
53-1003115-01
reload
2
The following summarizes the behavior of the reload command under a variety of conditions.
NOTE
MM = Management module
Examples To perform a cold reboot on the switch:
switch# reload
Warning: Unsaved configuration will be lost. Please run `copy running-config
startup-config` to save the current configuration if not done already.
Are you sure you want to reload the switch [y/n]?: y
See Also fastboot, ha chassisreboot, ha failover
Behavior of the reload command
Command HA synchronized HA not synchronized
Active Standby Active Standby
reload If executed on active MM,
reboots that MM
1 .
If executed on
active MM,
reboots that MM. The user is prompted to
execute the reload system
command. N/A
In FC mode, the running
configuration becomes
the new active
configuration. N/A
In LC mode, the running
configuration becomes
the new active
configuration. N/A
reload
standby Reboots the standby MM. Reboots the
standby MM.
Reboots the standby MM. Reboots the
standby MM.
reload
system Reboots the chassis and
remains the master MM. Not allowed. If executed on active MM,
reboots the chassis and
remains the master MM. Not allowed.
In FC mode, the startup
configuration is used. In FC mode, the startup
configuration is used.
In LC mode, the running
configuration is used. In LC mode, the running
configuration is used.