Brocade Network OS Command Reference v4.1.0 - Manual (Page 306)

268 Network OS Command Reference
53-1003115-01
fabric ecmp load-balance-hash-swap
2
fabric ecmp load-balance-hash-swap
Configures how to swap the input fields before feeding them to the hash function.
Synopsis fabric ecmp load-balance-hash-swap value
Operands value The control value. Valid values range from 0x0 through 0xFFFFFFFF.
Defaults None
Command Modes RBridge ID configuration mode
Description Use this command to configure how to swap the input fields before feeding them to the hash
function. The variable value for this command is interpreted as the bitwise control of the 212-bit
key. Each bit controls whether 2 adjacent bits of the key are to be swapped. This 32-bit control
value is written to all four hash swap control registers. This means that this value is replicated in a
32-bit block to form a 106-bit value. A value of 0x0 does not swap any input fields, while a value of
0xffffffff swaps all 106 input bit-pairs.
Usage Guidelines This command does not function in standalone mode.
Examples None
See Also fabric ecmp load-balance